![]() This image will need to be copied to the boot partition of a properly formatted SD card as described in Create a Bootable SD Card. The SD card image "-.sdcard" can be flashed to eMMC. SinoVOIP’s Banana Pi BPI-M2S comes with a 16GB of eMMC storage, expandable with a MicroSD slot on the underside, 4GB of LPDDR4 RAM, MIPI DSI and CSI display and camera interfaces, an HDMI port, a single USB 2.0 port, and a USB Type-C connector for power plus a Raspberry Pi-compatible general-purpose input/output (GPIO) header. Refer to the "Built Images" section of the Quickstart pertaining to the specific release you are using for clarification on image names. YOCTO_IMAGE in the instructions below refers to the Yocto image name that was used to build the image, and YOCTO_MACHINE refers to the machine that was selected to build the image. Note that the names of the images differ between releases. On the ports side, the BPI-M2 Ultra has 2 USB A 2.0 ports, 1 USB OTG port, 1 HDMI port, 1. Pre-built images are available on PHYTEC's Artifactory. If you have built your own images, then the images are located in: $YOCTO_DIR/build/tmp/deploy/images// The following instructions for flashing images from SD card will be useful if you want to: The phyBOARD-Zeta is delivered with a pre-flashed bootloader. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |